Thread Tools
May 04, 2017, 06:53 AM
Registered User
Thread OP
Discussion

3D Lab Print 3D Printed Spitfire XVI Power


Hi,

I have mostly stuff for 3S/4S now. What would be a good combo 3S to put into it ? I can imagine something like a 1000-1200-1400 KV w/ a 9" would do fine ? Recommended is 620KV @ 6S, so double that and 3S and I would likely have same power ?
Sign up now
to remove ads between posts
May 04, 2017, 08:00 AM
Registered User
I use one of these with a 2200 4s and 9x6. It gets going pretty well and balance is spot on.
May 04, 2017, 02:57 PM
Registered User
Thread OP
Great, I have something in that range. All my 4S is 1300mAh, 65C though.
May 13, 2017, 08:43 PM
Registered User
On mine I used what I had laying around.
Cc18, 2220 1200kv, 3s 1800, with a 9x7.5 cut down to 7"
Pulled 18 amp static so I know I'm pushing it some but it flew great.
May 30, 2017, 08:14 PM
An aspirational fast jet pilot
Great_Goose's Avatar
The back half of the vid below has my first 3Dlab Print Spitfire flying it.

Park21 Session 21/5/17 (3 min 55 sec)
Jun 04, 2017, 05:17 AM
Registered User
makind's Avatar
Im going with NTM 3530 1400kv, 9x6 prop and 3s2200


Quick Reply
Message:

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion 3D Lab Print - 3D Printed Boeing Stearman northernmonkey 3D Printed Planes 908 Oct 06, 2019 02:40 AM
Discussion 3D Lab Print Zivko Edge electric-2000 3D Printed Planes 202 Apr 21, 2019 04:46 PM
Discussion 3D Lab Print - Cessna 152 dz1sfb 3D Printed Planes 169 Mar 06, 2019 09:21 PM
Build Log 3D Lab Print 3D Printed Spitfire XVI build Fitz Walker 3D Printed Planes 13 Jun 14, 2017 03:44 PM
Discussion 3D Lab Print - Cessna 152 MarshallX Electric Plane Talk 2 Mar 20, 2017 09:20 AM