New Products Flash Sale
Thread Tools
Old Oct 13, 2004, 05:48 PM
rowdyates is offline
Find More Posts by rowdyates
Registered User
Question

Thread Locker


Finally been let loose on my Zoom as it's my birthday (she's a hard woman my wife ) and I'm curious, on the expoded parts page it highlights a number of screws to use thread locking stuff on, am I expected to take the thing to bits to add this myself or has it already been done and is just highlighting it for info, sorry for what could be a daft question, but I don't think it's too clear.

Cheers,

Rowdy
Sign up now
to remove ads between posts
Old Oct 13, 2004, 06:17 PM
ianm is offline
Find More Posts by ianm
ianm
ianm's Avatar
Hi Rowdy,

You should only have to use thread lock on screws marked if you have stripped it down and rebuilding after mods or a crash. Apart from fitting your electronics etc and setting up, the heli is factory built and marked screws should have been done there.
Obviously add locktight to any new parts added as needed and may I suggest you use the blue locktight (only a tiny amount needed) and not the red stuff as it locks so well it causes a problem if you need to undo those screws.


Ian
Last edited by ianm; Oct 13, 2004 at 06:27 PM.
Old Oct 14, 2004, 02:34 AM
rowdyates is offline
Find More Posts by rowdyates
Registered User
Cheers Ian,

Must admit was getting a bit worried I would have to strip it down from day one.

Hmm the stuff I've got from the model shop is the red stuff, I'll try and get some other if that's going to be too strong.

Thanks,

Rowdy


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Loctite / Thread Locker Red 61 Beginner Training Area (Aircraft-Electric) 5 Oct 26, 2005 07:52 PM