Hello RC GROUPS members
2 weeks ago I got a huge surpries when I opened up my DJI ground station ground end receiver,
I found out that this whole time there was not 1 but 2 uFL/IPX male antenna connectors inside the ground end receiver.
I wish I had found out sooner.
As far as I know Dji has not disclosed this useful information that I know of.
I would often wonder how come the TX has 2 diversity antennas while the RX has only one,
but never gave it much thought until now.
I wonder if having only 1 antenna is bad for the receiver because i've
read some where that if you turn any receiver on without the antennas attached it will burn out your RX
anyway once I found out about the 2 uFL/IPX connectors I set out to somehow install 2 diversity anttenas on my ground station RX, so I could increase my range & strengthen my signal,
the way I see it is, having 2 antennas is better than 1.
after trying a few different ideas this is what I came up with

I call it the GROUND STATION ROBZTA MOD

unscrew & open up your DJI ground station RX & find out if yours is like mine.

you can get the ROBZTA MOD on the link below:

http://www.ebay.com/sch/m.html?_odkw..._nkw=&_sacat=0

Subscribed. Thanks for passing this useful info.

but did you test it?