Thread Tools
Oct 11, 2016, 10:23 AM
Registered User
Thread OP
Discussion

My 3D Printed Micro FPV Quad.


I just finished designing/printing a small FPV frame that uses the Hubsan 7mm motors and props. I'm currently using an Inductrix board and will be switching to the BeeBrain tomorrow. The battery holder snaps into the bottom of the frame and is for 500mAh packs. The VTx is from the FX798T combo and the camera is one I bought from Surveilzone. I like that the antenna is completely protected and won't get damaged in a crash. I'm getting between 6 and 9 minutes of flight. The weight without a battery is 32.4 grams. Here's a quick video flying around at work. What do you think?

https://www.dropbox.com/s/d99cwrr1na...T0009.AVI?dl=0
Sign up now
to remove ads between posts
Oct 11, 2016, 12:29 PM
Registered User
UltimateMicroQuads's Avatar
Nice work, reminds me of the dreamcatcher frame.


Quick Reply
Message:

Thread Tools