Thread Tools
Aug 05, 2016, 01:10 PM
Registered User
Thread OP
Build Log

3D Printed ZMR/QAV/Falcon 250 Banggood Build


HI
Ive been flying off the shelf quads for years and done lots of the usual mods (replaced mosfets etc) and having bought a 3d printer (i3 diy kit from gearbest) a while ago ive been printing lots of different micro shells and putting hubsan/ micro scisky boards and cheap bangood (referred to as bg from here in) fpv setups on them and having lots of fun with my kids in the park but its time to move on to bigger and scarier things so im going to build myself a 250 based around the zmr/qav/falcon frame.
I have/will be buying the parts i cant print from bg and building it as they arrive so far ive printed the bottom and top frame and im ordering parts every week from my pocket money
There may be other things added to these lists as the build progresses.

3d printed parts...
(sidenote... i know printing the frame may be a complete waste of time and i might still end up buying a carbon fibre frame )
  • Top Frame
  • Bottom frame
  • Arms
  • Motor Protectors
  • LED Bumpers front & rear
  • XT60 Connector Holder
  • Camera Mount
  • GoPro Mount

Electronic Parts list...

this is just a quick placeholder at the moment but ill update it over the weekend with my bom and some piccies n stuff and update as parts arrive and are added to the build.

Also any comments on quality/compatibility of parts is very welcome.

mike
Last edited by mwhalen; Aug 12, 2016 at 01:26 PM.
Sign up now
to remove ads between posts


Quick Reply
Message:

Thread Tools