Thread Tools
Jan 01, 2016, 12:44 PM
Registered User
Thread OP

Tutorial - Simple DIY parallell charge board for 1S LiPo's (fits various connectors)


Hi all,

I have recenly got a couple of toy multirotors. One is still on its way, and one is being returned to Amazon because it had a dodgy motor

I've also ordered lots of spare batteries.

I have RC stuff already (a car) and none of my quadcopter lipo's have the same connector, so I made a quick parallell charge board to use with my Turnigy Accucell 6 charger.

The board uses modified PCB headers and fits micro-losi and mini-JST. I will test it with micro JST when my Cheerson CX-10 arrives.

Tutorial below:
http://www.instructables.com/id/1S-L...tiple-Connect/
Sign up now
to remove ads between posts
Jan 03, 2016, 12:03 PM
Registered User
Thread OP
have tested adn this doesn't fit the micro-jst 1.25 on the cheerson CX-10... I made a separate board for that but the pins were way too thick, so will buy some connectors online.


Quick Reply
Message:

Thread Tools