|
|
|
I'll say. I hope some reasonable degree of repair is possible. Although a high rpm prop? shudder...
Paul, did you manage to get the lopped off bits to the hospital? I'm not sure what your local practice is but here, double bagging is done, bag the digit or part in a dry waterproof bag, seal it and then put that bag into a bag filled with a slurry of chipped ice and cold water. If the cut is clean and considerately does not involve mangling too much anatomy, a skilled surgeon can sometimes salvage a lot. But if it is a hand in a blender ... shudder... might as well be a gunshot wound. |
|
|
|
|
|
|
All too mashed to cyno back on, thumb gone but the muscle is sewn back on. What wasn't apparent yesterday (I just got him to apply a sterile dressing to stem the bleeding as the RTV was on the way) he also slashed all 4 fingers down to the bone and severed 2 tendons in his little finger, may loose use of that too.
Gonna take for ever to get a lift if he ever tries to hitchhike, don't know how he is going to like anything on Facebook either... |
Latest blog entry: Just To Say Hello.......
|
|
|
|
|
sorry, didn't read your post, Paul. That super sucks!! I guess it's one thing to lose a finger cutting with a circular saw and another from an RC model.
Well either way it sucks Flying Pitcher and 63 others are feeling sad |
|
|
|
|
|
I shoulda called him Mike Jr.
Anyone tired yet of Mike Jr photos? |
|
Last edited by Flying Pitcher; Nov 27, 2017 at 09:26 PM.
|
|
|
|
|
|
|
|
|
|
Yes
|
|
|
|
|
|
Correct.
Month old |
|
|
|
|||
|
|
||
Latest blog entry: Just To Say Hello.......
|
|||
|
|
|
Close enough?????
|
Latest blog entry: Just To Say Hello.......
|
|
|
|
|
Yes
Very |
|
|
Thread Tools | |
Similar Threads | |||||
Category | Thread | Thread Starter | Forum | Replies | Last Post |
Discussion | Mike 'Powers' Hi Mike, only just seen this thread. Plankenstien | DENHAMDULAKE | Aerial Photography | 10 | Feb 03, 2023 12:41 PM |
Help! | Mike F / Motor Mike , i need your help ! | ozace | Electric Power Systems | 2 | Jun 03, 2008 01:12 AM |