Thread Tools
Dec 21, 2015, 02:19 PM
Registered User
Thread OP
Help!

Built my first 250 and having some match up problems


well got the cc3d controller programed thru Open Pilot but having trouble with fs-i6 linking up with it, using fs-ia6 receiver. Binding is fine but no response to open pilot transmitter set up. Any suggestions???
Last edited by axelfraser; Dec 21, 2015 at 02:28 PM.
Sign up now
to remove ads between posts
Dec 21, 2015, 03:48 PM
humayraykinaon's Avatar
were your quad powered on (battery plug in)? also on your transmitter are you on the same model? on OP GCS what software did you flashed it with? for CC3D you need 15.02 or below anything higher is for Revolution FC.
If your still having problem, you can download LibrePilot GCS https://librepilot.atlassian.net/wik...PDOC/Downloads
Last edited by humayraykinaon; Dec 21, 2015 at 03:54 PM.


Quick Reply
Message:

Thread Tools