Mini Graphite by Vladimir Models

I have for sale a 2 M Mini Graphite made by Vladimir Models.
I need to move some stuff because of not flying them enough. This airplane is almost(would be ) pristine except for that one small dent (shown in photos below) in the wing bottom about a half inch long
This a new build and only has 2 test flights from a hi-start. It needed some up elevator after the first. The second flight I got 7 mins.+ from less than a hundred foot launch.

This plane is ready to fly just charge the battery and add your receiver.
All the wiring is marked . If you fly with Airtronics this will be a snap.

This a full house sailplane that can be flown thermal and/or slope.

The specs are:

Carbon Kevlar Fuse
Hollow molded wings with carbon fiber wipers on flaps and ailerons
Built up tail surfaces
Carbon Kevlar slip on nose cone
Adjustable tow hook
Solid carbon wing joiner rod
Wiring harness for wing and fuse
4 Carbon fiber servo covers
4 TGY777MG digital servos for wing surfaces https://www.hobbyking.com/hobbyking/s...10sec_23g.html
2 TGY380MG digital servos for tail surfaces https://www.hobbyking.com/hobbyking/s...sec_15_6g.html
4 servo mounting frames in wing

I accept Pay Pal.

Shipping to California is $20
Thanks for looking; Frank
http://f3j.in.ua/en/mini-graphite.html