mini video transmitter with a stable power supply? - RC Groups
Shop our Airplanes Products Drone Products Sales
Thread Tools
Nov 02, 2015, 01:07 PM
Registered User
ToastLover's Avatar
Question

mini video transmitter with a stable power supply?


Hi,
As you can see in THIS thread I have problems with lines in the video even with a LC filter.
The transmitter I use is a FT952 5G8 200mW mini and my ESCs are KISS 18A, both run on 4S.
I connected the camera directly to my FPV goggles and I got no lines so the Vtx is definitely the cause of the lines in the video.

So is anyone here using a mini Vtx (I would use an ImmersionRC Vtx but I haven't enough space for one) with KISS 18A or similar ESCs without any problems? It should have at least 200mW power.
Sign up now
to remove ads between posts
Nov 03, 2015, 08:16 AM
Team AlienWarpSquad
I have no problems or lines with a FS 250mW or Aomway 200mW vTX and a Common Mode LC filter with KISS 18A ESCs.
Nov 05, 2015, 04:19 PM
Registered User
ToastLover's Avatar
Thanks for the suggestions but I found out that the Vtx wasn't the problem. It was one of the motors which are electrically connected to the antenna through the frame.