Thread Tools
Sep 30, 2015, 01:27 PM
Registered User
Thread OP
Discussion

How to wire loss signal aircraft finder for DJI phantom


I own an DJI Phantom, using NAZA-M V2 and DJI Transmitter that using D-Bus. Connection(s) from NAZA-M V2 to (ESC-Motor combination in 1 board) via M1,M2,M3,M4. I know that I need to install the finder device between NAZA-M V2 ( finder input) and ESC-Motor (finder output) but the thing make me in doubt :
(1): M1 (or M2, M3, M4)h each only has 3 pins ( I don't know what pin is (signal )what pin is (+) what pin is (-)
(2) ESC-Motor of DJI only has 2 pins which I also don't know which identifications pins are .
PLease help to identify them so I can wire them correctly. Please help.Thanks.
Sign up now
to remove ads between posts


Quick Reply
Message:

Thread Tools