Dynamite .15 Tuned pipe and header - RC Groups
Thread Tools
Jul 10, 2004, 09:49 AM
Registered User
joekitt's Avatar

Dynamite .15 Tuned pipe and header


I have 2 questions:

1. I have a Nitro Falcon with a Dynamite .15S engine. I would like to install a tuned pipe. Does anyone know of a source for a header for this engine?

2. I want to run the tuned pipe straight out the stern on
the back fo the boat. Will this create any problems?

Thanks

Joe
Sign up now
to remove ads between posts
Jul 12, 2004, 07:18 PM
RC boat Rock Star
I don't know how much help it will be on this boat, it's kind of a slug in stock form. Anyway, look around at your local Hobby Shop to see what they have that might fit. An Associated or similar header might do the trick, one that goes back and up, one made for an on-road car mounted upside down. A tuned pipe from any .12-1.5 car should work.
One problem the you will probably run into is that all of this extra hardware hanging off the back of the boat will change the center of gravity so you might have to add some weight to the front to compensate for it.
Jul 22, 2004, 07:27 PM
RC boat Rock Star
Oops, my bad. I was thinking of the outboard tunnel boat. You can try the header from a Miss Bud if it'll clear the radio box. On my .12 powered boats, I've been using a Traxxas header from most of their car and truck kits. It has a right-angle and is bent slightly upwards to help clear going over a radio box. The only thing that I'm not quite sure of is that the Dynamite may have a wider bolt hole spacing than other motors in it's class.