Cleanflight iNav (navigation-rewrite) project - Page 1057 - RC Groups
Shop our Airplanes Products Drone Products Sales
Thread Tools
This thread is privately moderated by DigitalEntity, who may elect to delete unwanted replies.
Today, 03:13 PM
Registered User

Possible to do SmartAudio with Omnibus F3?


I have a wing I put together before the SmartAudio patches were getting integrated into iNav trunk. It's running a "Flip32 F3 Omnibus" (http://www.readytoflyquads.com/flip-32-f3-omnibus). I have UARTs 1 & 2 tied up with Crossfire and GPS respectively. I can't see a way to get to the TX pin of UART3 to enable SmartAudio.

Can I remap something? Recompile something, and put it out over PPM5-8? Am I stuck with soldering directly to the processor?

All solutions welcome, but I'm not willing to step down to SBUS, and am reluctant to solder directly to the chip - I'm liable to glop it and fry the board I fear.
Sign up now
to remove ads between posts