Shop our Airplanes Products Drone Products Sales
Thread Tools
Jun 27, 2004, 07:10 PM
Registered User

Any problem with bipe dihedral and incidence??? TM!

Hi all

Half way through converting the Kyosho TM for e flight. Sure enough the upper wing have more than dihedral than necessary. The instruction mentioned it for lower wing but not upper wing. Its just said make sure both side the same!!!!!Darn!

So with minimal tool, I built the upper wing as good as I can, and now the wing strut is too short. While I can mount the strut, but I'm almost 1 inch short. I can see the wing got stress bit especially the lower wing.

I lower the center cabane by drilling a lower mounting hole by 5/8 of an inch. This lower the upper wing overall. My strut still short of about 2/8-3/8 in and the stress of pulling the lower wing up for mounting seem lesser now.

Are there any danger or risk of wing falling apart and flying characteristic? Or I can just mount the wing up and leave it for a week, eventually the wing/wood structure will conform to the new angle?

The shape of TM is taking place ie flatter dihedral on top wing compare to the bottom one.
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Any problem with Futaba crystal in JR receiver ? fchristian Electric Heli Talk 13 Mar 01, 2012 03:40 AM
Hacker B50 6S - any problem with 12 cells? davidleitch High Performance 10 Jun 06, 2005 10:41 AM
Any problem with this? IceWind Parkflyers 0 Apr 16, 2005 08:37 PM
any problem with using pinions for rc cars on a plane gearbox? jeff262 Power Systems 3 Jan 10, 2004 03:46 PM
Problem with Venus dihedral brace? Bill Germanson Sport Planes 18 Aug 21, 2003 10:15 AM