New Products Flash Sale
Thread Tools
Old Jun 27, 2004, 02:24 AM
RCDad is offline
Find More Posts by RCDad
Registered User

RE: servo wiring question

I am going to be putting JR servos into an Airtonics receiver. What do I need to do with the wiring?

I tried a search on this but nothing came up. I remember two wires needed to be swapped, but I forgot which ones.

Thanks for any help.
Sign up now
to remove ads between posts
Old Jun 27, 2004, 04:01 AM
steve lewin is offline
Find More Posts by steve lewin
Registered User
You will only need to swap wires over if it's an old Airtronics receiver with the pre-Z connectors. All makes have used compatible wiring for at least the last 5 or 6 years.

If you do need to do change anything it's the postive and negative wires that need swapping.

Ah - found it ! Details on the Fatlion Servo Wiring page

Old Jun 28, 2004, 11:28 PM
RCDad is offline
Find More Posts by RCDad
Registered User
Thanks Steve,

The website showing the wiring configurations was great.

Got it all wired up, thanks again

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion GWS mini / std servo wiring question kleggo GWS (Grand Wing Servo) 0 Jun 29, 2006 02:32 PM
Retract servo wiring question.. LBarron Radios 1 Nov 19, 2004 08:54 PM