Thread Tools
This thread is privately moderated by Vamooska, who may elect to delete unwanted replies.
May 10, 2004, 11:49 AM
Trader Rating: 198
Vamooska's Avatar

WTB EDF brushless setup for T-33

I am looking for an EDF that will accept a brushless motor that will fit into a Kyosho T-33. If it already has the BL in it...thats ok. New or Used.
reply via pm.
Sign up now
to remove ads between posts
May 10, 2004, 11:50 AM
Trader Rating: 0
Registered User
I got one for ya!!!
May 10, 2004, 01:52 PM
Trader Rating: 198
Vamooska's Avatar

Thanks for the pm itty

But that one wont fit
Thanks anyways
May 10, 2004, 07:31 PM
Trader Rating: 374
Don't cut the Yellow Wire
dr.E's Avatar
Best deal in town is to find an aveox 1010 2y or DF motor. Pick up also a castle 35 amp esc for it. If not I think there is someone selling a 1615 2y for 75.00 out there that would work fine on 7-8 cells.
May 10, 2004, 08:00 PM
Trader Rating: 110
Registered User
I have a Wemotec Minifan 480 than was bench run but has never been mounted in a plane. It includes two props and nose cones but is missing the retaining nut. I'll take $30 for it including shipping. I also have a brushed motor that fits this fan if you decide to go that route.

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Feigao brushless setup for T-IFO Alan T. Scratchbuilt Indoor and Micro Models 3 Mar 28, 2007 09:07 AM
Please advise on optimal brushless setup for T-Hawk philipnow Power Systems 4 Sep 20, 2005 11:12 PM
WTB Brushless setup for EDF mitchamus Aircraft - Electric - Airplanes (FS/W) 2 Jun 10, 2004 08:22 PM
WTB: Flying Wing and Brushless setup for GWS in San Jose, CA DerrickT Aircraft - Electric - Airplanes (FS/W) 1 Jun 13, 2003 11:26 PM
WTB - Brushless setup for an Electrostreak Heli Slime Aircraft - Electric - Airplanes (FS/W) 0 Jul 01, 2002 06:18 PM