New Products Flash Sale
Thread Tools
Old Dec 27, 2001, 01:16 AM
boomerace is offline
Find More Posts by boomerace
Been There! Done That!
boomerace's Avatar

My new design Bipe turned into a Mono


Hi,
Half way into the bipe design I changed my mind (or lost my mind) and decided to build this. I'll keep you updated. I will start with a GWS A but have made room for a M100 if I don't like the performance. Wing cord is only 5.5" and wing span is 28". It will weigh out somewhere between 5 and 6 oz. so it may be a handfull. Pico servos and GWS RX w/Azaar antenna 7 cell 300 NiMH.
wish me luck,
boomer
Sign up now
to remove ads between posts
Old Dec 27, 2001, 11:23 PM
Gene Bond is offline
Find More Posts by Gene Bond
Crash Master
Gene Bond's Avatar
Looks like a Gnat with a fuse, or a Tiny with wingtips, with a fuse!

Should fly great...
Old Dec 28, 2001, 02:28 PM
boomerace is offline
Find More Posts by boomerace
Been There! Done That!
boomerace's Avatar
Wing ribs are thinner than Tiny as I was looking for a little better wind penetration. Orignally had full ribs all the way but decided struct. I didn't need them or the weight so cut away back of every other rib. Coming along nicely should have flight report in a couple of days on it and the bipe if the weather allows.
boomer


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
link to my new depron bipe design plans kevbeer 3D Flying 0 Mar 11, 2005 03:00 AM
My new Bantam Bipe CA'ed fingers Parkflyers 40 Nov 30, 2004 08:22 PM
Help! Need Help with my new design...again!!! duaner Foamies (Kits) 11 Jul 23, 2004 06:16 AM
Need Help with my new design duaner Foamies (Kits) 6 Jul 20, 2004 11:58 PM
TB3D, my new design. Thomas Manson 3D Flying 11 Apr 01, 2004 12:45 AM