ball in swash mod ? - RC Groups
Thread Tools
Apr 06, 2004, 12:59 AM
Registered User

ball in swash mod ?

Where would be a good place to get a ball in swash mod for a aerohawk?
Sign up now
to remove ads between posts
Apr 06, 2004, 09:11 AM
Registered User
Lynxman's Avatar
I made my own. I found a regular ball-link and driller the hole in the ball to 3mm. Then I enlarged the hole in the swashplate so that the ball could rotate in there with the shaft going through it. then I glued a little plastic washer to the underside of the ball inside the swashplate to hold it in. I used medium CA and a piece of thin piano wire to apply just a tiny amount of CA on the washer to avoid getting it on the ball. Works great!
Apr 07, 2004, 04:07 PM
Registered User
I think that I would rather just buy one or the swash with the ball already installed. Just need to know where to get one besides from what people say they are crooks.
Apr 07, 2004, 04:11 PM
Registered User
terryk's Avatar
The Hummingbird swash fits the 'Hawk quite nicely and you can get those from just about any hobby store
Apr 07, 2004, 06:33 PM
Registered User
Thanks. I will try to find one.
Apr 07, 2004, 09:34 PM
Registered User
If Hummingbird swashplate fits aerohawk then you can buy Cupid Swashplate (Ball mod Installed) for $10.99 from:
Just a search for Cupid Swashplate on this site.
Hope this help.
Apr 07, 2004, 11:14 PM
Razy Crandom Guy
If the Hummingbird swash is a direct fit for the Aerohawk, Dennis over at carries swashes with balls pre-installed. I have ordered from Dennis and his service is absolutely AMAZING.

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Ball in swash mod thorine Micro Helis 16 Jun 08, 2004 06:53 AM
Ball in swash mod thorine Micro Helis 5 Oct 21, 2003 09:05 AM