Thread Tools
This thread is privately moderated by Jim.Thompson, who may elect to delete unwanted replies.
May 21, 2014, 04:48 PM
Entropy is happening!
Jim.Thompson's Avatar
Thread OP
Discussion

Yet another light plank!


I have been busy learning to draw in 2D LibreCad, which is an open source CAD drawing system designed specifically for Linux. That has been a challenging but very rewarding adventure in itself.
Also, I've been working on the design of my next project; Entropy build thread here:
https://www.rcgroups.com/forums/show....php?t=2164114

Also I have been doing a bit in the shed building another light plank out of the remaining scrap foam that I salvaged from the tip. This one will be very similar to the 1200 I finished recently (flew again yesterday - very nicely too), but will be 1400 span. The max size panel that my gravity cutter can cut is 700mm, so that determined the size. I expect to be able to make this one to an even lighter wing loading that the smaller one. I've learned a few more tricks along the way, as happens.
Sign up now
to remove ads between posts


Quick Reply
Message:
Thread Tools