|
|
|
|
|
|
|
|
||
|
Quote:
You can make the bind last longer by increasing the KYOSHO_BIND_COUNT, doubling the value will double the time. Is the RX reacting to the bind at all? LED pattern change? Pascal |
|
|
||
|
||
|
Quote:
Led is always blinking. Non stop At succesfull bind :When it binds,led stops blinking,no more blink. If i unplug bind cable ,led comes on (no blink) and works. https://s7.dosya.tc/server17/fgwgtd/..._rx_2.zip.html i will change values of bind count and log again |
|
|
||
|
||
|
Quote:
//#define KYOSHO_FORCE_ID_HYPE //Kyosho constants & variables #define KYOSHO_BIND_COUNT 5000 https://s7.dosya.tc/server17/0dvl8o/2x_time.zip.html Led : led blinkin |
|
|
||
|
||
|
Quote:
|
|
|
||
|
|
|
STM32FLASH Failed to Init Device - Resolved!!
I'm very happy to report that my issue has been resolved. It has turned out to be an issue with the FTDI adapter I purchased initially.
I first purchased this adapter through amazon: HiLetgo FT232RL FTDI Mini USB to TTL Serial Converter Adapter Module 3.3V 5.5V FT232R Breakout FT232RL USB to Serial Mini USB to TTL Adapter Board for Arduino Sold by: HiLetgo This adapter seems to be incompatible with my IrangeX IRX4 Plus. Is it seems to be incompatible because while it passed a simple echo test, whenever I tried to access the module either in Arduino IDE or in Flash Multi to read or write to it I would get: Failed to init device. stm32flash 0.4 http://stm32flash.googlecode.com Interface serial_w32: 57600 8E1 To summarize, I tried a lot of things to remedy this but with no success... Then, after Benzo99 suggested I try a CP2102 adapter in place of the the FT232RL, I ordered one and the CP2102 worked! Oddly, I was not able to get it to work through Arduino IDE (received the same error) . It only worked with Flash Multi 0.5.0. Everything seems fine now! Bootloader installed and working too! Thank you all of your help and patience! I hope by posting this someone having the same issue can get the help they need! Safe flying! -Eric |
|
|
|
||
|
Quote:
Can you confirm that the bind works with : //#define KYOSHO_FORCE_ID_FHSS #define KYOSHO_FORCE_ID_HYPE I'm puzzled since you said it worked earlier but it should fail as well... |
|
|
||
|
||
|
Quote:
I dont und why its happened |
|
|
||
|
||
|
Quote:
|
|
|
||
|
||
|
Quote:
From the release notes: DSM Forward Programming
|
|
|
||
|
||
|
Quote:
Thankyou |
|
|
||