Autogyro blade shaping sanding block. - RC Groups
Thread Tools
This thread is privately moderated by Mud Duck Bill, who may elect to delete unwanted replies.
Mar 20, 2014, 02:27 PM
Registered User
Mud Duck Bill's Avatar
Build Log

Autogyro blade shaping sanding block.


A quick and easy way to make a blade shaping / finish sanding block. I hope it turns out as nice for you as it did for me.
Well I guess we a limited to how much we can say in each picture.
So after Harding the balsa block it will raise the grain in the wood so just run it over the fine paper on the master to smooth it off. That's why you don't dismantle the jig till often the balsa is dry.
I guess you get the picture in the other post.


Bill
Last edited by Mud Duck Bill; Mar 20, 2014 at 02:37 PM.
Sign up now
to remove ads between posts
May 26, 2014, 08:29 AM
Registered User
What a super piece of work. I must make a jig and several blocks.

Thread Tools