Thread Tools
This thread is privately moderated by Sweetieinsf, who may elect to delete unwanted replies.
Feb 28, 2014, 03:32 PM
Master of Disaster!
Sweetieinsf's Avatar
Thread OP
Mini-HowTo

Dynam F6F Hellcat Crash Proofing Part 2


So I've finished installing the CF rods in the wings and made adapters for the RCLander 105 degree retracts with oleos. In addition I built an "avionics" board and wing attaching screw straps. Click on the pictures for my comments.

Name: CF rods in wings.jpg
Views: 205
Size: 663.4 KB
Description: Here is a pic showing the location and sizes of the CF rods. I used a straight edge to mark the locations on the wing before drilling.

Name: IMG_20140228_111515_581.jpg
Views: 162
Size: 706.1 KB
Description: Here you can see the aluminum plates I epoxied into the wings for the RCLander retracts

Name: IMG_20140216_195743_353.jpg
Views: 154
Size: 446.9 KB
Description: I made this "avionics" board out of plastic to give a nice flat surface to mount the receiver, Eagle A3 board, and clean up the inside

Name: IMG_20140216_195648_363.jpg
Views: 43
Size: 347.1 KB
Description: In this picture you can see the finished dual control rod setup for the elevator. I found it had a fair amount of flex in hard manuvers with the single rod setup.
Sign up now
to remove ads between posts


Quick Reply
Message:
Thread Tools