Thread Tools
Old Dec 15, 2001, 08:37 PM
mkirsch1 is offline
Find More Posts by mkirsch1
Registered User

ModelTech 1/3 Scale Cub


I've been drooling on the 1/3 scale Cub ARF from Hobby People. I think it would be something of a challenge to electrify, don't you?

Is there anything big enough to power this beast?
Sign up now
to remove ads between posts
Old Dec 16, 2001, 01:32 PM
GordonTarling is online now
Find More Posts by GordonTarling
Supersonic Engineering
GordonTarling's Avatar
Ought not to be a problem.
Power system depends on whether you want brushed or brushless motor.

For brushed, I'd look at a geared Astro 90 - not much else around with that sort of power level, except maybe a Plettenberg.
Tom Hunt's twin Dewalt setup may also work.

For Brushless, a big Plettenberg or Aveox with belt drive or gearbox should do it.

Cells? If you're going with one motor, then I think 32 is about the most you'd be able to buy a controller for easily. If you go with two motors, then maybe 2 x 24 cells packs or similar would be a better choice.
Old Dec 16, 2001, 05:24 PM
mkirsch1 is offline
Find More Posts by mkirsch1
Registered User
That's a start. Thanks.

I was beginning to think that I got shunned in these forums... Nobody's responded to my last couple of threads.
Maybe my quesitons were just too obscure.


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Sold Bob Nelitz 1/3 scale Cub and Pegasus 320 btomlinson Aircraft - Fuel - Airplanes (FS/W) 0 Jan 09, 2006 07:25 PM
Wanted 1/3 scale cub bipe22 Aircraft - Fuel - Airplanes (FS/W) 1 Nov 26, 2005 02:07 AM
Award Winning Highly Modified B USA 1/3 Scale Cub (RTF) probuilder Aircraft - Fuel - Airplanes (FS/W) 0 Jun 07, 2004 08:43 PM