Shop our Airplanes Products Drone Products Sales
Thread Tools
Dec 24, 2013, 03:17 AM
Registered User
Help!

DJI Phantom 2 + AVL58 (wiring help advanced+)


I just got my phantom 2 and a new AVL58, I connected the wires and everything seemed fine. The TX was sending video and powering on great.

I had everything soldered and heat wrapped. I picked the phantom up and let the TX and the iOSD dangle as I carried it to my computer, plugged in the iOSD to update firmware and then noticed that the AVL58 was not on any longer.

I noticed that the soldering could have slipped loose somehow on the red (positive) going from Phantom, so I reattached it and still no luck.

I took out a continuity tester (something I'm new to) and got continuity on the whole setup being wired, but once I disconnect the plug to the TX, I lose continuity.

I don't have the tools on hand to open the Phantom and see if I somehow pulled the included uplink cable out of the board, but that seems unlikely.

What did I do?
Sign up now
to remove ads between posts


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion DJI AVL58 Antennas MisterWill FPV Equipment 2 Jun 10, 2015 06:04 AM
Discussion DJI AVL58 on a F450 notlkk Multirotor Drone Talk 1 Dec 11, 2013 01:20 AM
Sold DJI AVL58 5.8Ghz FPV System $215 BenK944 FPV Equipment (FS/W) 1 Jul 07, 2013 08:13 AM
Help! DJI AVL58 5.8ghz - Tx/Rx - cloverleaf Patricia0318 FPV Talk 0 Mar 14, 2013 08:22 AM
Discussion Fatshark Google + DJI AVL58 compatibilities Helnet Multirotor Drone Electronics 0 Mar 13, 2013 08:36 PM