Thread Tools
Old Feb 28, 2004, 09:30 AM
furyflyer2 is offline
Find More Posts by furyflyer2

Aveox 36/30/2 question


The instructions for the Aveox say's that it comes timed for "normal" rotation. In the Quick EP I'm running it reversed, do I need to re-time it for running it back-ward?
Sign up now
to remove ads between posts
Old Feb 28, 2004, 10:14 AM
Krona is offline
Find More Posts by Krona
E-Heli
Krona's Avatar
No, you do not need to re-time brushless motors

Bjorn
Old Feb 28, 2004, 12:51 PM
furyflyer2 is offline
Find More Posts by furyflyer2
I flew it around today, it was alittle windy, I found that it did not roll axle, and loops are not big. It seams not to have enough power. Could I need to change my electronic timing advance, I have it set on standard?
Old Feb 28, 2004, 12:52 PM
furyflyer2 is offline
Find More Posts by furyflyer2
Also I have the throttle type on low rpm range, does that sound right?
Old Feb 28, 2004, 09:57 PM
Krona is offline
Find More Posts by Krona
E-Heli
Krona's Avatar
Yes that sounds right.
What pinion are you using, a 12tooth pinion is recommended for best performance, but a 10 or 11 works good.
Also try the Quick 3D paddles, I think it's the best $5 upgrade available for the helicopter.

Bjorn
Old Feb 28, 2004, 10:25 PM
furyflyer2 is offline
Find More Posts by furyflyer2
I'm using a 11t pinion.
Old Feb 28, 2004, 10:38 PM
Krona is offline
Find More Posts by Krona
E-Heli
Krona's Avatar
that's cool, it works good with your 4S4P


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
WTB Aveox 36/30/2 or hacker C-50 v22chap Aircraft - Electric - Airplanes (FS/W) 0 Mar 14, 2004 07:13 PM
WTB Aveox 36/30/2 or hacker C-50 v22chap Aircraft - Fuel - Airplanes (FS/W) 0 Mar 14, 2004 07:10 PM
Aveox 36/30/2 Stearmandriver Electric Heli Talk 43 Feb 26, 2004 07:54 PM
Phoenix 60 governor mode with an Aveox 36/30/2? GGoodrum Castle Creations 10 Jul 30, 2003 07:21 PM
Logo 10, Aveox 36/30/2 and 4s6ps E-Techs, some numbers... GGoodrum Electric Heli Talk 56 Jun 26, 2003 06:49 PM