|
|
Thread OP
|
Build Log
((( Ultimate LRS ))) |
|
Last edited by flipflap; May 17, 2020 at 11:04 AM.
|
|
|
||
|
Quote:
|
|
|
||
|
|
Thread OP
|
I'm using just 3 connections : +, - and serial PPM out. For simplicity (and pin accessibility), the PPM out is on the same pin that is used for PPM in on the TX.
Serial PPM is then sent to APM, on which the servos are connected. So it's very simple : two cables between APM and OLRS -a cable for serial PPM -a cable for telemetry data |
|
|
|
||
|
Quote:
So no RX side RSSI to APM? |
|
|
||
|
|
|
|
|
Last edited by nicnet; Nov 21, 2013 at 01:53 PM.
Reason: clarification
|
|
|
|
So on the 1W HK modules, is the VCC to RFM23BP also 3.3?
If so, it should be easy enough to cut that track and apply 5v right? (like on your 100mw to 1W conversion? Acknowledged that 1W in this case is at best 0.5W, likely less ... |
|
|