|
||
|
Quote:
http://www.itluxembourg.lu/site/wp-c...iagram-JR1.png and where would the power from the ESC come? Is there a similar wiring diagram for the HK Micro Pilot? |
|
|
||
|
|
|
Thread OP
|
The best is to start by reading a lot about ardupilot, pixhawk and so on, there's a lot of ressources on internet. A good place for general information about this is http://ardupilot.org/ or https://pixhawk.org/ and a good forum is https://diydrones.com/
Then everything will become clear |
|
|
|
|
|
I am thinking about using a zener diode to adjust 5v to 3,6v, but I am not sure which is the maximum power consumption of the atmega in arduino pro mini. Would be enough with 500mw disipation power from zener? Must use raw pad or vcc pad to solder the zener in bee board?
|
|
|
|
||
|
Quote:
|
|
|
||
|
||
|
Quote:
Ultra-Small Size DC-DC Step Down Power Supply Module 3A Buck Converter Adjustable 1.8V 2.5V 3.3V 5V 9V 12V https://s.click.aliexpress.com/e/FmZkDvQ |
|
|
||
|
||
|
Quote:
https://www.ebay.com/itm/10X-Diodo-Z...F9SB:rk:2:pf:1 |
|
|
||
|
||
|
Quote:
Orange RX using software SPI? I trying find pinout on 1w receiver. And i found this: #define SDO_pin 9 #define SDI_pin 8 #define SCLK_pin 7 #define IRQ_pin 2 #define nSel_pin 4 Why? |
|
|
||
|
||
Thread OP
|
Quote:
Of course IMO it's better to change the SDI/SCK resistors than to change the atmega voltage, but it should work too. |
|
|
||