The continuing quad saga
All remains relatively well with the reborn HPQ1 with its shiny new HobbyKing electronics.
I say "relatively" only because the number one motor kept popping its endbell during yesterday's flight adjustments. I'd removed the endbells in order for the quad to fit in its rather nice hard-shelled case which is SOP for that model.
Swapping out the number 1 and number 3 endbells fixed the problem, so I've temporarily marked that number one endbell with a Sharpie until I can engrave it or otherwise label it. The 8x3.8 APC slow-flyer props generate more thrust than stock, something to keep in mind when replacing them.
Good old Chad, aka "TheOne420" did a superb job of setup over at the hobby shop, properly activating the auxillary channel so that I can now switch the self-leveling mode on the fly. He even got the battery voltage indicator on the KK2 to work by soldering the leads of a JST connector to a couple of pads underneath the board. The positive lead went to a pad marked "AREF" and the negative was soldered to ground, or "GND." Once plugged into the male JST pins on the power distribution board, success!
I still want a better frame and motors, but we'll see how this one works in the long run.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||The Holder Saga Continues||FL Knifemaker||Life, The Universe, and Politics||20||May 26, 2013 11:23 AM|
|WTB HVP (HL) Beaufighter (a saga continues)||faust||Aircraft - Electric - Airplanes (FS/W)||0||May 22, 2003 07:28 AM|
|Miniflash Saga Continues||enigmabomb||Parkflyers||4||Apr 19, 2003 07:17 PM|
|Yippee!||Saga of CLAWS Helping Hand Continues||Don Sims||Humor||47||Dec 12, 2002 09:34 AM|
|The Zagi Saga continues (Dual Rates and Threaded Rods)||safetyboy||Slope||5||Nov 07, 2002 03:57 PM|