Thread Tools
This thread is privately moderated by Steve H., who may elect to delete unwanted replies.
Feb 10, 2004, 06:33 PM
Trader Rating: 624
Registered User

CD-Rom motor for sale

20 turns of 26g wire in star wind, weighs 33 grams. Made up the mount and the bearing tube from aluminum and used the original cdrom 3mm shaft for the prop shaft, just had to take a dremel to it while it was spinning so I could put a c-clip on the back of it.
It turns a 6.5x5 prop at around 6 amps on a 3s lipo pack. It has 12 N45 magnets glued in to replace the stock weak magnet.
Requires a 3mm prop adapter.
$30 shipped in the US

Pay-Pal preferred
Sign up now
to remove ads between posts
Feb 10, 2004, 07:20 PM
Trader Rating: 118
I will take it

MO is the best I can do.
Will have it out in the morning

Feb 10, 2004, 07:33 PM
Trader Rating: 624
Registered User
Sent you a PM

SOLD pending payment
Last edited by Cue; Feb 10, 2004 at 07:39 PM.

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Piccolo Cd-rom motors for sale rbeall04 Power Systems 0 May 05, 2004 12:04 AM
rewound cd-rom motor for direct drive tail rotor Ron van Sommeren Electric Heli Talk 0 Apr 26, 2004 08:28 AM
Brushless CD-ROM motor for GWS warbirds beanie Power Systems 0 Mar 01, 2004 08:58 PM
Anyone using a CD-ROM motor for a tail motor? GBR2 Micro Helis 5 Jan 29, 2004 09:29 PM
32X CD-Rom Drives--FOR SALE kist2001 Aircraft - Electric - Airplanes (FS/W) 0 Apr 23, 2002 04:33 PM