Turnigy AE-100A Brushless ESC doesnt work
im german so sorry for my bad english.
Today i solder the Turnigy AE-100 ESC and the Turnigy 500 H3126 Brushless outrunner 1600KV together and tested it with a MX-16 Hott.
If the throttle stick is on bottom position and i connect the battery (tested with 3 and 4 cell lipo) the ESC flashes red and Beep Beep fast.
If the throttle stick is on top position and i connect the battery the ESC is in program mode. But if i put then the throttle stick to bottom postion to select a program, nothing happens.
Trouble shooting says:
"After power on, motor does not work, such an alert tone is emitted and the red LED flashes at the same time. "Beep-Beep-" (Every Beep-Beep- has a time interval of about 1 second)".
--> Input voltage is abnormal, too high or too low.
"After power on, motor does not work, such an alert tone is emitted; "Beep-Beep-" (Every Beep-Beep- has a time interval of about 0,25 second)".
--> The throttle stick is not in the bottom (lowest) position.
I think that the Beep Beep is every 0,25 sec. but the red LED also flash, so i dont know wheres the failure. its a mix of both
My batterys are ok (tested three) and the throttle stick is also ok because it works with an other ESC.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||Turnigy Delux ESC 100A wont work! Help!||planebldr||Power Systems||16||May 11, 2016 09:02 AM|
|For Sale||Turnigy Super Brain 100A Brushless ESC||hmlow0||FPV Equipment (FS/W)||0||Aug 05, 2013 08:57 AM|
|Sold||Turnigy Super Brain 100A Brushless ESC||hmlow0||FPV Equipment (FS/W)||1||Jul 01, 2013 09:53 AM|
|Sold||NIP, Turnigy AE-45A brushless esc with SBEC 5-6V/4A||Ranchhand||Aircraft - Electric - Power Systems (FS/W)||2||Feb 10, 2013 08:15 AM|
|Help!||Turnigy Sentilon 100A HV ESC only works with 72 Mhz Rx's||leider||Power Systems||6||Jun 07, 2009 07:55 PM|