Thread Tools
Jan 28, 2004, 06:57 PM
Registered User

Save those hard-disk platters.....make great motor plates and mounts


Some uses:
Motor back-plates.....the one shown mounts up to an AVEOX 1015 powered at 700 watts.
Made with a simple steel hole-saw.

Aluminium heat sink material

Anywhere a 1/16" or 1/32" (some are thicker) aluminium plate is needed
Sign up now
to remove ads between posts
Jan 28, 2004, 06:58 PM
Registered User
Forgot the picture
Jan 28, 2004, 08:03 PM
Right Honorable Member
flatfour's Avatar
You can make clocks too!

This is an old 8 incher from a 30 meg drive. Fine 80's technology


Thread Tools