Thread Tools
This thread is privately moderated by Jack Crossfire, who may elect to delete unwanted replies.
Jun 16, 2013, 11:51 PM
Registered User
Jack Crossfire's Avatar
Thread OP
Discussion

Twit studio



It was a lot darker in there than expected. The apartment actually has more lighting.












Sadly, this 1st attempt at a smaller monocopter was a fail. Before 3D printing made ABS the most popular material, everything was made of depron. This is either too small or too heavy to fly under the maximum RPM. The required speed of the wing was too high, so no increase in motor power would fix it.



Paper plates are the easiest source of depron, but limit the size.






Sign up now
to remove ads between posts


Quick Reply
Message:
Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Twit Jessica Stern (public figure) 7oneWo1f Life, The Universe, and Politics 22 Apr 17, 2013 01:33 PM
Discussion The Twit on Twitter Jacques Flambeau Life, The Universe, and Politics 60 Jul 21, 2010 10:20 AM
Help! Twit needs advice carpman1 Dock Talk 4 Aug 06, 2009 09:24 AM
OK, help this newbie twit figure out a piroetting problem. WJ Birmingham Micro Helis 8 Dec 10, 2003 12:04 AM