Foamyfactory Yak-54 and Hymaxx motor
I have 40' of Fanfold and the plans for the foamyfactory Yak. I want to build the 36" version with a brushless motor. I also want to use 3s1p Etec LiPos.
It looks like the Hymaxx motors are starting to get back in stock and I would like to use one of them.
My question is.... which motor i.e. 2015-xxx, and should I get it with a planetary gearbox or adapt it for the GWS 350C gear box? If going planetary, which gearing and prop? If going the GWS route, which gearing and prop?
Oh, and should I get the Phoenix 10 or 25 for an ESC?
I have Motocalc, but I would like to hear of some solutions that have been put to the test.
Thanks in advance for your experiences!
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Question||BME Yak 54 Brushless motor||skysoljah||3D Flying||1||May 03, 2007 02:18 PM|
|Discussion||hyperion yak-54 motor mount||tarts||3D Flying||2||Feb 06, 2007 09:45 AM|
|Discussion||E. F. Yak 54: Which Motor||submarco||3D Flying||0||Nov 18, 2006 03:08 AM|
|Yippee!||Foamyfactory Yak-54 40" - CG?||rc4metoo||Foamies (Kits)||0||Jul 14, 2004 02:31 PM|
|Control horn length on FoamyFactory Yak 54||H-tail||3D Flying||1||Jan 12, 2004 08:30 PM|