newbie naza problem - please help!
So got a F450 finally and am trying to set it up but have hit a technical hurdle:
When I plug the naza into the laptop and launch the assistant software it goes almost immediately to the firmware update page. It says my naza has v2.02.
When I try to click onto another tab in the assistant software a little red message appears saying "you must update the controller firmware" and it won't allow me to access any other tabs.
If I try to update it says there is no update necessary so i'm stuck.
Any ideas what's wrong??
thanks in advance
Sounds like you're running the v2.10 assistant (written for the Naza V2), which is looking for the latest v3.10 firmware. This has been withdrawn by DJI and is no longer available for download.
You need to install the previous version of the assistant (v1.8), which thinks v2.02 is the latest firmware. Download it from here, in the 'Naza-M Firmware v2.02' section:
You can have both versions of the assistant installed at the same time. When the revised v3.11 (or whatever) firmware is released, use the v2.10 assistant to upgrade from your v2.02 firmware to that.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||Problem Dji F450 + NAZA (video) Help!!!!||Joao Monteiro||Multirotor Drone Talk||2||Apr 22, 2013 12:25 PM|
|Discussion||Problem with Naza configuration, help please.||InfinitR||Multirotor Drone Electronics||6||Mar 16, 2013 12:33 PM|
|Discussion||tricopter problems pleas help||swar||Multirotor Drone Talk||13||Mar 14, 2013 09:31 AM|
|Discussion||Newbie RCMK Starting PROBLEM?? HELP||gzmann||Racing Boats - Internal Combustion||4||Mar 11, 2013 10:21 PM|
|Discussion||Newbie help! rudder problems||hecmac||Beginner Training Area (Heli-Electric)||5||Feb 23, 2013 12:30 PM|