OSD Pro + Altimeter v4 showing negative values? - RC Groups
Thread Tools
Mar 14, 2013, 06:17 AM
Registered User

OSD Pro + Altimeter v4 showing negative values?

Just noticed that my altimeter shows negative values in the ET software, sometimes reaching -1200+ ft. Not sure how to calibrate this or if this an expected result? Also would I have to apply tape to it due to the sun hitting it possibly?
Sign up now
to remove ads between posts
Mar 15, 2013, 05:05 PM
billpa's Avatar
Hi, sorry to hear about this issue. What is almost certainly happening is that the system thinks you have an altimeter V3 connected.

The following should take care of it:
0) I'd recommend running our latest release software (10.44) from the support page of our website
1) connect the elogger + altimeter + osd to your PC
2) bring up the OSD Pro configuration page, and click OK
Mar 16, 2013, 08:18 AM
Registered User
I've tried a factory reset and it seems to be working but I'll know after I've flown. Does the sun hitting the altimeter have anything to do with the erroneous values?
Mar 18, 2013, 01:04 PM
billpa's Avatar
Hi, hitting the sun would only have a slight effect. Placing a piece of tape or similar over the altimeter would be good, if the altimeter's sensor will be in direct sunlight.

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
For Sale 99 Eagle tree OSD Pro with 150 amp E logger V4 and GPS module andysubaru FPV Equipment (FS/W) 2 Dec 04, 2013 05:58 AM
Sold ET, V4 logger/V4Gps/Guardian/Osd Pro/Alti Panzlflyer FPV Equipment (FS/W) 5 Mar 11, 2013 04:57 PM
Sold Eagle Tree V4 100A Logger, GPS, OSD Pro, Guardian Stabilization Mystic3D FPV Equipment (FS/W) 5 Feb 18, 2013 11:24 PM
Sold Eagle Tree Pro OSD + V4 Data logger + GPS peter.braswell FPV Equipment (FS/W) 2 Jan 16, 2013 07:35 PM
Question OSD Pro, eLogger V3, GPS V4 problems updating firmware in OSD Pro jbfoamy Eagle Tree Systems 23 Jun 02, 2012 03:59 PM