USB driver fail - RC Groups
Shop our Airplanes Products Drone Products Sales
Thread Tools
Mar 10, 2013, 05:40 PM
Registered User

USB driver fail

After installing the Data recorder software.

Following the instructions I connected the Osd pro and the Guardian stabilizer to the V4 logger then connected the usb to 2 different pc's through a hub and not through a hub but both computers show error code 43 for the usb device and the Logger has a constant flashing red light.

If I disconnect the OSD pro and the Stabilizer it simply says it cant find the usb driver.

If i try to start the Data recorder software it wont start and tells me to connect the Logger even if it is connected.

I have run out of options. Anyone got any ideas?

EDIT: just tried it without the stabilizer connected and it seems to be connecting now?

I figured it out i thought the upper row of pins was the lower row!!
So i was putting the gps and the osd in each others pins.
Last edited by C06alt; Mar 10, 2013 at 06:09 PM.
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Question drivers for turnigy FTDI usb chip john howard Multirotor Drone Electronics 1 Jan 13, 2013 01:49 AM
Help! Castle link driver fail in Win7 64-bit MegaTesla Castle Creations 1 Feb 25, 2011 06:32 PM
Discussion G4 - Interlink interface failed - asking for device driver jgs99v Simulators 1 Feb 13, 2008 01:16 PM
Help! E-SKY USB interface Cable Driver needed emielkosse Simulators 16 May 11, 2007 07:46 PM
Discussion Hitec USB cable driver mmormota Simulators 0 Apr 19, 2006 06:55 AM