Walkera v450 D01 with 3gx and dx8
Im converting my walkera v450's flybarless unit to a 3gx unit and running it with 2 sats and using my dx8.
Ive gone through the set up process and everything works fine... except..
The motor randomly starts in little short bursts with the throttle stick at lowest point.. increasing the stick moves the pitch like it should but just increases the frequency of these randoms bursts from the motor..
When I plug the battery in the 3gx does it start up thing and all is good.. several seconds later the walkera esc beeps indicating its armed.. and this is when the motor starts randomly bursting on and off..
I know with the castle ice esc you have to program the esc and set end points..
is this the case with the walkera esc? if so how do i do it?
any help will be much appreciated!!
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Walkera V450 D01 V2||iflyhelis||3D Electric Heli Flying||23||Mar 11, 2013 01:52 PM|
|Discussion||Rtf v450 d01 v2||iflyhelis||Hobby Stores||0||Aug 03, 2012 03:52 PM|
|Discussion||dx8 settings with 3gx fbl....Help!!!||RC10TC||Beginner Training Area (Heli-Electric)||1||Dec 13, 2011 04:09 PM|
|Discussion||Walkera 200 D01 with Tx 2801 PRO||utmanaren2002||Radios||1||Nov 21, 2010 10:53 PM|
|New Product||Walkera v200 d01 - i||bigW||Electric Heli Talk||8||Jul 24, 2010 08:09 PM|