Trader Rating: 13
OpenPilot CopterControl (OPCC)
Original OpenPilot CopterControl for sale. I got it off a user here but I don't need it. I flew it to test it and it works and its stable.
I've also updated the bootloader and firmware for it. Should be ready to go and configure for you multirotor!
Comes with receiver cable.
From a new comer, OpenPilot Ground Control Station (GCS) software is very well developed. Makes changing setting and setup a breeze Great way to get into the OpenPilot community.
It may not be the "CC3D" but don't get it wrong, this original OPCC board performs!
I was really surprised. There is a function called TxPID. With that you can basically tune the P and I setting with a knob on your remote.
For those interested in gimbal control, you can use this board to stabilize a gimbal too
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|For Sale||OpenPilot CopterControl||peabody124||Aircraft - Electric - Multirotor (FS/W)||6||Feb 18, 2013 02:12 PM|
|Sold||OpenPilot CopterControl for Sale.||mnegrete||Aircraft - Electric - Multirotor (FS/W)||0||Feb 17, 2013 02:15 PM|
|Sold||OpenPilot CopterControl||peabody124||Aircraft - Electric - Multirotor (FS/W)||2||Feb 02, 2013 11:19 AM|
|Sold||Xaircraft 450 Pro w/ OPCC (OpenPilot) BNF - Quadcopter||Polishchris||Aircraft - Electric - Multirotor (FS/W)||1||Jan 27, 2013 03:11 AM|
|Sold||OpenPilot CopterControl (OPCC)||TheFernMan||Aircraft - Electric - Multirotor (FS/W)||2||Jan 20, 2013 08:17 PM|