Thread Tools
Old Feb 25, 2013, 10:46 PM
magno_grail is offline
Find More Posts by magno_grail
Registered User
Question

Tail Rotor Shaft size


Hi All,
I am looking into building a multi-rotor using 450 main rotors but since I do not need cyclic I wanted to substitute a tail rotor pitch control for the swashplate. The 450 main shaft is 5mm, does anyone know which helicopters use a 5mm tail rotor shaft?
I tried posting this on the VTOL forum but is seems they all use propellers, not rotors.
Thanks.
Sign up now
to remove ads between posts
Old Feb 26, 2013, 05:54 PM
flyalan is offline
Find More Posts by flyalan
Registered User
flyalan's Avatar
I do know that the original Synergy N5 used a 5mm tail shaft. They were later upgraded to 6mm but the 5mm hardware is still available.

Alan
Old Feb 28, 2013, 02:12 AM
magno_grail is offline
Find More Posts by magno_grail
Registered User
Thanks, I will check into it. I found the Trex 600 manual lists part sizes and it uses a 5mm tail rotor shaft also.


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion 250 tail rotor shaft size and speed Ken59 Electric Heli Talk 11 Feb 11, 2013 12:33 AM
Discussion Hobbyking tail rotor shaft 42.8mm - cheap extended tail rotor shaft Atomic Skull Mini Helis 2 Sep 29, 2012 03:01 PM
Discussion Question: T-Rex V2 - Tail : Tail Rotor Shaft/hub/Set Screw Santini Mini Helis 4 Apr 09, 2008 12:03 PM
Tail rotors - shaft driven versus seperate tail motor driven prop JohnM Micro Helis 2 Jun 10, 2004 01:15 PM
Tail shaft size on the Zoom? Final output ratio for it as well vs main shaft? Admiral_Red Mini Helis 1 Jun 08, 2004 05:40 PM