Rotor Pitch Control
I am looking into building a multi-rotor VTOL using 450 size helicopter blades and rotor heads. Since I do not need cyclic control, only pitch, I was thinking of using a tail rotor pitch control unit on the mainshaft. The 450 mainshaft is 5mm. Does anyone know what size helicopter (500/550/600/etc.) tail rotor uses a 5mm shaft?
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||KK2.0 Multi-rotor LCD Flight Control Board with Firmware v1.5 and Servo Leads||yarg||Aircraft - Electric - Multirotor (FS/W)||3||Jan 13, 2013 01:32 PM|
|Found||KK2.0 Multi-rotor LCD Flight Control Board||Donnyv||Aircraft - Electric - Multirotor (FS/W)||0||Jan 12, 2013 07:05 PM|
|Sold||Brand New - KK2.0 Multi-rotor LCD Flight Control Board||yarg||Aircraft - Electric - Multirotor (FS/W)||3||Jan 12, 2013 04:29 PM|
|Sold||HobbyKing Multi-Rotor Control Board V2.1 (Atmega168PA)||sixstringlz||Aircraft - Electric - Multirotor (FS/W)||2||Jan 09, 2013 10:15 AM|
|corona cf rod for tail rotor pitch control||derway||Electric Heli Talk||1||Nov 08, 2003 05:55 PM|