DJI Naza-M Assistant Software Error Code List - RC Groups
Thread Tools
Feb 22, 2013, 06:28 AM
Discussion

DJI Naza-M Assistant Software Error Code List


Here is the Naza-M Assistant Software Error Code List. Please read so that you can have a better understanding of the errors and how to fix it!

CFG-ERR
Configuration error, this may be caused by firmware upgrade from the old version, or abnormal Tx calibration. Re-calibrate your transmitter, power cycle your controller, and check all of the parameters.

VOL-LOW [4]
Voltage low

SN-ERR
Your S/N is not available, Please contact your dealer (Place of purchase)

VOL-LOW[6]
Voltage low

IMU-ERR
IMU ERROR,Please contact dealer. (Place of purchase)

X1-ERR
You’ve chose parameters tuning by X1/X2 channel with Tx Knob, but no signal detected on X1/X2 input channel, or Tx didn’t powered on.

X2-ERR
You’ve chose parameters tuning by X1/X2 channel with Tx Knob, but no signal detected on X1/X2 input channel, or Tx didn’t powered on.

PMU-ERR
Please check the connection among battery, MC and PMU.

RX-ERR
Please make sure you are on the RC page of the NAZA Assistant Software, select the right receiver type or check the receiver connection, after that power cycle your controller to take effect.

COMPASS-ERR
Compass data is abnormal, please restart your Controller, if you still get this error, please contact your dealer (Place of purchase)

ERROR [25]
IMU initialization failure, may be caused by crash. Please contact dealer (Place of purchase)

ERROR [26]
Please perform Advanced Calibration.

ERROR [27]
GPS not calibrated, or magnetic field interference. Please calibrate GPS again in good condition.

Please contact your dealer for all technical support questions
We hope this answers your questions!
Last edited by DJI INNOVATIONS; Feb 26, 2013 at 10:55 PM.
Sign up now
to remove ads between posts
Apr 25, 2017, 07:39 PM
Mr Take no prisoners
PeteDee's Avatar
What about DB ERROR that I am getting with the Lite software
?


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Help! DJI Naza M Assistant 2.0 and 2.02 bolarobric Multirotor Drone Talk 16 Jun 01, 2015 09:58 PM
Help! DJI Naza Assistant software wont run Andjons Multirotor Drone Talk 10 Aug 15, 2013 08:18 AM
Build Log DJI F550 NAZA ARF COMPLETE BUILD and DJI NAZA ASSISTANT w/ TX CALIBRATION >VIDEOS< patrick21x Multirotor Drone Talk 11 Nov 30, 2012 08:13 PM
Help! DJI F450 NAZA/GPS will not connect to assistant software, any ideas would be great. jasper7821 Multirotor Drone Electronics 2 Oct 24, 2012 06:53 PM
Discussion dji naza error code vol low 4 homersainty Multirotor Drone Talk 1 Jul 22, 2012 10:04 AM