Help with CNC wiring! - RC Groups
Shop our Airplanes Products Drone Products Sales
Thread Tools
Feb 09, 2013, 08:44 AM
Registered User
Help!

Help with CNC wiring!


Hi everyone,
I am a CNC newbie, just assembling my foam cutter, and need to extend the wiring to stepper motors... I am not able to source this where I live, but am visiting the US in a couple of weeks, so am planning to order from mouser or similar..the motors are bipolar type, 1.8A, and the wiring I need to extend (by max. 2m) is labelled as 24AWG.Does anyone have any recommendations, from Mouser or otherwise? I'd really appreciate a nudge in the right direction!
Sign up now
to remove ads between posts
Feb 09, 2013, 09:10 AM
Registered User
Ward Hagaman's Avatar
If my memory serves, I got my wires from the local home store (Home Depot) and used common wiring usually used for sprinkler controls. Nothing really exotic. I did use silicone insulated wire for the power to the bow because I liked the flexibility of it...available at the hobby shop...normally used for RC battery leads.
Feb 10, 2013, 04:00 AM
Registered User
Thanks for your time, will keep that in mind when I visit!
Feb 12, 2013, 11:38 AM
Registered User
dpot's Avatar
for stepper motors i use 8 cor car trailer wire and for the bow speaker wire


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Help with wiring an H-bridge dmccormick001 DIY Electronics 27 Feb 10, 2013 04:45 PM
Discussion Xieda wiring help needed treff Beginner Training Area (Heli-Electric) 3 Jan 27, 2013 11:32 AM
Help! Lipo 2s balance wiring help please dzgn Batteries and Chargers 3 Jan 26, 2013 10:05 AM
Discussion Wiring/soldering help with 900mhx system pete914 FPV Talk 11 Jan 20, 2013 03:20 PM
Help! need some electronic wiring help abletowinginc DIY Electronics 0 Jan 14, 2013 07:12 AM