Got a perry carb for sale. Not for sure what size motor it would go on. If you know anything about this, feel free to post. The round part that goes into the crank case has an OD of .5 inches. The throttle barrel spins freely too.

shoot me a pm with a price shipped

does it look something like this on the part where it goes into the crankcase?

Thanks for the reply. No it doesn't have the recessed part like yours. It is flat all the way around. I should clarify here, I was told it is a perry carb. I have never had a perry carb or used one but was told at a swap meet some time ago that this is what it is.

Good morning.
Do you happen to have the model number?
If not can you measure the OD a little more closely. Here is a link to the Perry Carbs. It would help if you measure out to .001
http://www.perrypumps.com/prod01.htm

thanks for the reply and the info. I am out of town until tuesday night, so I will measure it then.
adam

pm'ed