Thread Tools
Old Feb 03, 2013, 11:54 PM
demondriver is offline
Find More Posts by demondriver
Up-Out-&-Gone
demondriver's Avatar
Quote:
Originally Posted by rrg View Post
Anything yet?????
It works fine on 18-volts but wont go over.
RCG Plus Member
Latest blog entry: RC Slimer from Ghostbusters!
Sign up now
to remove ads between posts
Old Feb 04, 2013, 07:42 AM
NDT_UTS_LU is offline
Find More Posts by NDT_UTS_LU
Registered User
which type ESC used by you
Old Feb 04, 2013, 01:03 PM
demondriver is offline
Find More Posts by demondriver
Up-Out-&-Gone
demondriver's Avatar
Quote:
Originally Posted by NDT_UTS_LU View Post
which type ESC used by you
These are HET High end technology ESC SIr.
RCG Plus Member
Latest blog entry: RC Slimer from Ghostbusters!
Old Feb 04, 2013, 02:58 PM
Eddie P is offline
Find More Posts by Eddie P
Official Boat Bum
Eddie P's Avatar
Did you swap out the ESC's from left to right to make sure it was isolated to the ESC?

I have never heard that sort of beeping so I wonder if you just have a partial failure of your speed controller. But there could be some interplay between motor/wire/battery combination. Either way, even if you isolate it to the ESC, the ESC will have to be replaced IMHO. But trouble shooting like you are doing at least prevents you from replacing the wrong component Good luck and happy gremlin hunting.
Old Feb 04, 2013, 05:18 PM
Flexserve is offline
Find More Posts by Flexserve
Avoid The Ground!
Flexserve's Avatar
Pulse Width Modulation (PMW)? I'm sure this changes per load put on the ESC.... if I'm not mistaken. That's why you get a simple "putter" motion and not a rotation on the EDF...

Other possibilities include over voltage for receiver's BEC, Interference from high amp / high voltage battery cables running close to signal cables for the receiver.


Just some thoughts...
Old Feb 04, 2013, 07:29 PM
demondriver is offline
Find More Posts by demondriver
Up-Out-&-Gone
demondriver's Avatar
Quote:
Originally Posted by Flexserve View Post
Pulse Width Modulation (PMW)? I'm sure this changes per load put on the ESC.... if I'm not mistaken. That's why you get a simple "putter" motion and not a rotation on the EDF...

Other possibilities include over voltage for receiver's BEC, Interference from high amp / high voltage battery cables running close to signal cables for the receiver.


Just some thoughts...
Flex Sir the high foltage wires running next to the servo lead from the esc to the RX might be a winner I will do some tests wednsday when I dive back to work. . .I'm on a break today & tomorrow.

Thanks Boss!
RCG Plus Member
Latest blog entry: RC Slimer from Ghostbusters!


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion SimonK esc and pancake motors problem? milo12 Multirotor Talk 9 Apr 27, 2014 05:41 AM
Help! E-flite Pro60 ESC problems kawika1kalina Power Systems 2 Jan 19, 2013 03:04 PM
Help! Motor/ESC problem after soldering?? low beeps and motor wont start calle3 Micro Helis 0 Jan 14, 2013 01:58 PM
Help! ESC Problem with Turnigy 9x Wrice4 Power Systems 2 Jan 10, 2013 09:20 AM
Discussion TX, RX, ESC, BEC, where is my problem? flybyjohn Power Systems 10 Jan 03, 2013 07:09 PM