Originally Posted by jasper7821
I updated my DX8 and wanting to make sure all the settings remained the same.
When I turn the TX off the I get the throttle to bump some and the fail safe highlights and the pointer moves to it as I remember how the fail safe works.
BUT when I use the manual switch and put the NAZA into fail safe, the pointer moves into fail safe and highlights blue but the throttle stays at whatever position it was at before I flicked the switch.
I'm just wondering if this is normal or is the throttle pointer also supposed to move when manual going into fail safe with the switch.
That is expected. The receiver only sets all the channels to their failsafe values when it really has lost signal. What you did with the switch was just set the NAZA's "U" input, while the throttle (and other channels) remain as sent by the TX, which is still talking to the receiver.