Thread Tools
Jan 27, 2013, 10:24 AM
Registered User
Help!

OSD Pro and PPM Rx, what to do with RUDDER ?


Hey Guys,

im using OSD Pro with v4 Logger on my Twinstar.
Signal is comming from a Frsky Rx set to sum PPM

all working great.

the only problem i have is were to connect the rudder servo ?
or were to get the rudder signal ?

cant connect it on the Rx because of the ppm, and the OSD has no rudder output

is it possible to get the rudder singal on AUX1/2 IN ?

thanks Billpa
Sign up now
to remove ads between posts
Jan 28, 2013, 08:55 PM
billpa's Avatar
Hi, the OSD Pro does not have a way to support rudder - this would need to be connected from the receiver to the rudder servo directly.

Does the rudder output of the receiver not continue to operate, when PPM sum is selected?
Jan 29, 2013, 02:56 AM
Registered User
no it just outputs ppm.

maybe you can think about an rudder out (without mixing) for the next alpha if the osd is set to PPM on AUX1/2 ?

would be great. but for now i just dont use rudder.
Jun 16, 2013, 05:32 AM
Registered User
I found my Rx still had some outputs and just had to shuffle the channels to suite. this was a FrSky D8R-PlusII.
Last edited by Barney1942; Jun 16, 2013 at 05:40 AM.


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion 1 battery or 2? Help with power to ET eLogger & OSD Pro flywmoi Eagle Tree Systems 4 May 29, 2013 08:22 PM
Discussion What to do with Sandy Hook Fokker Ace Life, The Universe, and Politics 14 Jan 15, 2013 11:13 PM
Question 1 battery or 2? Help with power to ET eLogger & OSD Pro flywmoi UAV - Unmanned Aerial Vehicles 0 Jan 10, 2013 12:24 AM
Discussion what can I do with this? karlik Foamies (Scratchbuilt) 6 Jan 03, 2013 08:26 PM
Discussion OSD PRO with PPM RX srnet Eagle Tree Systems 1 Oct 07, 2010 12:25 AM