Paperclip Mod -
The basic idea is to take a standard (or, preferably, one size up) paper clip and carefully shape it round the dogbone guide as per the picture. It tedious, but should be a neat fit and stay in place without help when you finish.
Then carefully go round the upper and lower parerclip/plasic join with 5 min epoxy - making sure none gets in the guide slots, of course.
I usually solder the 2 loose ends together as well, but this isn't really essential.
Also - I have done the job without removing the rotor head, just a bit more awkward.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||mini LST2 - Brushless Mod + Servo Mod||mattgm||Cars - Trucks and Parts (FS/W)||1||Jul 22, 2012 07:34 PM|
|Sold||Turnigy 9 x with er9x installed backlight mod, usb programmer mod + 4 rx||KiTCyclic||Aircraft - General - Radio Equipment (FS/W)||3||Jun 20, 2012 06:01 AM|
|Caption This||Why you don't throw paperclips at coworkers||willhaney||Humor||5||Apr 25, 2007 08:38 PM|
|the little paperclip next to your post||Robert Parisot||Site Chat||12||Jan 22, 2004 11:36 AM|