Originally Posted by Zbak
Well when I fly it inside or out, the heli will shake for a second and could mess me up in the process. It usually happens in the begginning of my flights and not the end. Please give me advice on what to do but it is nothing to serious. Also, what is the best way to flip it for the first time?
Its not very clear whats happening.... do you mean its shaking in the air after you take off, or its shaking as you spool up? If its shaking on spool up, thats normal, and caused by the loosness of the blades, but should go away quickly as the head gains speed. Most times its much more noticable when you spool down.
If thats not it, a vid would help us help you.
Originally Posted by matiac
I'll turn on my radio for mine, leave it on for a few seconds, then plug in the battery, trying to keep it as still and level as I can, and that's no small feat with my fat fingers. Hope this helps?
Here, here is a little known secret. You are worrying over nothing. Yes the manual says "NOTICE: Do not allow the helicopter to move until the
blue LED on the 3-in-1 control unit is solid. "
but the fact of the matter is, the heli wont
initalize untill the heli is sitting still. You can actualy plug in the battery and then "fly" the heli around the room in your hand, and it wont actualy initalize till you are done having fun and set it down.... try it.
Then you can stop worrying about trying to keep it still while plugging in the battery. Just plug it in (dont worry about keeping the heli level either, I hold mine nearly upside down when I plug it in) and set it down.