flying homebuilt - RC Groups
Thread Tools
This thread is privately moderated by chyorn, who may elect to delete unwanted replies.
Jan 10, 2013, 10:03 AM
Trader Rating: 207
Adam Stallcup

flying homebuilt

So I built a home made plane using all brand new electronics about a year or so ago. It has the ar6400 that I programmed to use an external esc. The motor is an AP05 from hobby city, the esc is a brushless 10 amp with a diode coming off the power wire to drop the voltage enough to run the ar6400. The fuse is a carbon fiber arrow. I flew it a time or two, and I don't have the right size elevator on it. The elevator needs to be smaller, and the horizontal stab needs to be bigger as it was a bit pitch sensative. I then put it on a shelf where it has sat ever since. I have got $95 in it all new, I am asking $60 shipped. It is set up for a two cell lipo around 400 milamp.
Sign up now
to remove ads between posts
Jan 10, 2013, 10:17 AM
Trader Rating: 207
Adam Stallcup


ws is 28 inches and 24 long
Jan 10, 2013, 01:21 PM
Trader Rating: 100
Registered User
PM sent
Jan 13, 2013, 07:21 PM
Trader Rating: 207
Adam Stallcup



Any takers? Anyone out there? Did I mention it is brand new stuff???
Jan 14, 2013, 08:04 PM
Trader Rating: 66
Pilot, Co-pilot, Navagator
nemoskull's Avatar
entire planes are a hard sell if not used. you might get more selling the guts.

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion $TREE and FFF Homebuilt FPV pusher ideas chanyote66 Foamies (Scratchbuilt) 6 Dec 28, 2012 01:12 AM
Sold Variac for a Homebuilt Hotwire Cutter... soarsimon Aircraft - General - Miscellaneous (FS/W) 3 Jun 23, 2012 11:15 AM
Question Autopilot on a homebuilt plane? koskok2695 3D Foamies 0 Mar 15, 2012 09:36 AM
Yippee! Vid of my 26" homebuilt flying wing Hogster Flying Wings 15 Jun 15, 2004 05:21 AM