Thread Tools
Old Jan 10, 2013, 03:53 AM
_AL_ is online now
Find More Posts by _AL_
Slow builder
_AL_'s Avatar
Discussion

Cheap HK TX issue


Hi,

I just received one of these,
http://www.hobbyking.com/hobbyking/s...Lipo_RTF_.html

When it arrived I found the TX not working. Not wanting to pay to send it back to Hongkong (which would cost more than I paid for the thing) I thought I'd have a look for any obvious issues.
I found the issue, the red wire from the TX battery box has come away from the circuit board.
Does anyone know where the positive wire should be soldered to the circuit board? I've asked if anyone can provide a pic in another sub forum but posting here on the off chance that someone knows off the top of their head.

Thanks.
Al
Sign up now
to remove ads between posts
Old Jan 10, 2013, 04:17 AM
SadSack is offline
Find More Posts by SadSack
Registered User
picture will help And link was dead for me
Old Jan 10, 2013, 04:34 AM
_AL_ is online now
Find More Posts by _AL_
Slow builder
_AL_'s Avatar
Sorry for poor photo.
Name: Dscf1042small.jpg
Views: 88
Size: 68.3 KB
Description:
I suspect it should go to V+ (bottom centre of board) but I'd prefer not to kill it on an assumption.
Thanks.

Al
Old Jan 10, 2013, 08:51 AM
hammer22 is offline
Find More Posts by hammer22
Registered User
I think it pretty safe to say it goes to the V+ pad since it looks like the black battery negative wire goes to a pad marked V-
Old Jan 10, 2013, 09:19 AM
dmccormick001 is offline
Find More Posts by dmccormick001
Dave the Rave
dmccormick001's Avatar
I think hammer22 is right, look for other clues, like the wire length, shape, etc. to see if it looks like the red wire was once attached to that V+ pad. Sometimes, if in doubt, I will melt the solder on the pad I think is correct to see if there are any pieces of the end of the original wire that broke off still visible. If they come off onto your soldering iron, it's a pretty safe bet you're on the right track.
Old Jan 11, 2013, 06:26 AM
_AL_ is online now
Find More Posts by _AL_
Slow builder
_AL_'s Avatar
Thanks.
I got the TX fixed today only to find the same dodgy soldering on the rudder servo so it's still not flyable.
I'll wait to see what HK have to say before I try any more soldering.

Thanks again for the assistance all.

Al


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion How to use HK-T4A (Reg HK 4ch tx) for buddybox with my 9x Koo Radios 2 Oct 20, 2012 03:47 PM
Sold HK 900MHZ 200mW Tx/Rx , Lipo, Cheap-o Cam + wires templton89 FPV Equipment (FS/W) 0 Aug 14, 2012 11:28 AM
For Sale 2 FlySky CT6B V2 M2 Tx's /HK-T4A M2 Tx flashbang Aircraft - General - Radio Equipment (FS/W) 0 Mar 31, 2012 07:20 PM
For Sale HK 450 setup with HK-T6A V2 tx/rx Bandwidth88 Aircraft - Electric - Helis (FS/W) 3 Mar 13, 2012 09:38 PM